QMS Magicolor WX User Manual page 160

1 Turn off the printer and remove the power cord.
2 Open the manual feed tray by lightly pressing on the top-
right corner, and then tilt the tray out and down.
Caution: The OPC belt is extremely sensitive to bright lights and
direct sunlight. Limit exposure to 800 lux (the average fluorescent
lighting in an office) of light to under 2 minutes. If exposure
exceeds this, put the belt in a dark place to recover; depending on
exposure, recovery may take up to 2 hours.
Also, handle the OPC belt carefully, using either the two green
side-handles or using the green end-handle when possible. It is
extremely sensitive to hand oils and scratches both of which
reduce print quality. When you must set it down, gently lay it on a
clean, lint- and dirt-free surface, such as on fresh paper for the
printer.
3 Lift the OPC belt cartridge handle up to unlock it, and pull
the cartridge straight out of the printer.