Related Manuals for QMS Magicolor LX
Summary of Contents for QMS Magicolor LX
- Page 1 Update to the magicolor ® ® Printer User’s Guide To update your QMS magicolor LX Printer User’s Guide, please replace pages 2-25 through 2-26 and pages 6-13 through 6-16 with the pages in this package. 1800414-001A...
- Page 3 Hold the cleaning pad by its tab and place the white side against the orange roller closest to the green felt strip. Align the center rib of the cleaning pad with the triangle on the green felt strip. Keep the white side of the pad touching the orange roller closest to the green felt strip as you press the pad forward and down into the slot under the green felt strip (fig.
- Page 4 Chapter 2 Snap the separator pawl unit closed (fig. 2.18). Fig. 2.18 Close Separator Pawl Unit (front view) 2 - 2 6 I n i t i a l P r i n t e r S e t u p...
- Page 5 (towards the rear of the unit), pull it out of the printer, and discard it (fig. 6.3). Fig. 6.3 Remove the Cleaning Pad Remove the new cleaning pad and the new oil bottle from their protective bags.
- Page 6 10. Pull open the spring latch on the outer edge of the oil bottle retainer, and lift the retainer up and toward the center of the printer (fig. 2.19). NOTE: Normally, a little oil remains in the fuser slot in which...
-
Page 7: Replacing The Waste Toner Pack
12. Hold the new oil bottle, spout end down, bottle label toward the front of the printer, over its slot in the fuser unit (fig. 2.19). 13. Lower the bottle into place, making sure the spout on the bottom aligns with the pin in the fuser slot. - Page 8 Grasp the tab on the top edge of the old waste toner pack, and pull it out of the printer. 6 - 1 6 C o n s u m a b l e s a n d P r e v e n t a t i v e M a i n t e n a n c e...