Garmin GTN 725 Pilot's Manual page 481

NOTE: There is an installer option to turn on a system message that will
be provided anytime crossfill is turned off to alert the pilot that flight plans
are not being crossfilled.
This data is crossfilled only if crossfill is turned on by the pilot:
• Active navigation (flight plan)
1. While viewing the System Setup page, touch the Crossfill key
to toggle between Enabled and Disabled Crossfill.
2. When Crossfill is about to be enabled, you will be prompted
to note that data will be overwritten in the other unit. Touch
or
OK to enable Crossfill or touch Cancel to return to the System
Setup page without enabling Crossfill.
GTN-GNS Crossfilling:
• GTN to GNS – Active flight plans, active direct-to, User waypoints
• GNS to GTN – User waypoints
1. While viewing the System Setup page, touch the GNS Crossfill
Settings key to reach the GNS Crossfill settings.
2. Touch Auto GNS Crossfill to enable Crossfill and send the
Active Flight Plans and the active Direct-To course to the GNS
unit.
190-01007-03 Rev. D
Figure 16-22 Confirming Crossfill Selection
Figure 16-23 GTN-GNS Crossfill Selection
Garmin GTN 725/750 Pilot's Guide
Touch OK to Enable
Crossfill With Dual Units
Touch OK to Enable Auto
Crossfill With Dual Units
Touch OK to Manually
Transfer User Waypoints
Foreword
Getting
Started
Audio &
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
Charts
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Services/
Music
Utilities
System
Messages
Symbols
Appendix
16-21
Index