Garmin GTN 725 Pilot's Manual page 140

Foreword
Getting
Started
Audio &
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
Charts
Wpt Info
NOTE: As an alternate means of loading an approach, the Channel ID key
allows you to select the channel ID for a SBAS approach for the current
Map
destination. The channel ID for the SBAS approach is available from an
approved approach chart. If duplicate numbers are available for a channel,
Traffic
a list will be available where you may select the desired approach.
Terrain
Weather
Nearest
Destination Airport
Services/
Music
Approach Waypoints
Utilities
System
Messages
Symbols
Appendix
6-12
Index
5. Touch the Transition key and then touch the key for the desired
transition. The selected Transition will be shown in white on
the Procedure page Approach diagram. Unselected Transitions
will be shown in grey.
Touch To Select
Transition
Figure 6-15 Select Approach Transition
6. If desired, touch the Channel/ID key, then use the numeric
keypad to select the channel number, and then touch the Enter
key. The Channel and ID are typically loaded automatically if
they are present.
7. Touch the Load Approach key. The Active Flight Plan page
will be displayed. The approach waypoints are placed at the
end of the flight plan and the unit will automatically sequence
to them after the en route waypoints.
Figure 6-16 After Loading an Approach
Garmin GTN 725/750 Pilot's Guide 190-01007-03 Rev. D