Setting The Super Password - HP 1910 User Manual

Item
Access Level
Password
Confirm Password
Password
Encryption
Service Type

Setting the super password

A management-level user can set the password for non-management-level users to switch to the
management level. If the password is not configured, a non-management-level user cannot switch to the
management level.
To set the super password:
1. Select Device > Users from the navigation tree.
2. Click the Super Password tab.
Figure 76 Setting the super password
Description
Select an access level for the user.
Users of different levels can perform different operations. User levels, in order from low
to high, are as follows:
•
Visitor—Visitor-level users can perform only ping and traceroute operations. They
cannot access the data on the device or configure the device.
•
Monitor—Monitor-level users can perform ping and traceroute operations and access
the data on the device, but they cannot configure the device.
•
Configure—Configure-level users can perform ping and traceroute operations, access
data on the device, and configure the device. However, they cannot upgrade the host
software, add/delete/modify users, or back up/restore the configuration file.
•
Management—Management-level users can perform any operations on the device.
Set the password for the user.
Enter the same password again.
Select the password encryption mode:
•
Reversible—Uses a reversible algorithm to encrypt the password before saving the
password.
•
Irreversible—Uses an irreversible algorithm to encrypt the password before saving the
password.
Select the service types for the user to use, including Web, FTP, Telnet, and terminal.
You must select at least one service type.
95