HP 1910 User Manual page 90

4. Click Apply.
Table 13 Configuration items
Item Description
Enable or disable the port.
Port State
After you modify the operation parameters of a port, you might need to disable and then
enable the port to make the modifications take effect.
Set the transmission rate of the port:
•
•
•
•
•
Speed
•
•
•
•
•
•
Set the duplex mode of the port:
•
Duplex
•
•
Set the link type of the current port, which can be access, hybrid, or trunk. For more
information, see
Link Type
To change the link type of a port from trunk to hybrid or vice versa, you must first set its link
type to access.
Set the default VLAN ID of the interface. For more information about setting the PVID, see
"Configuring
PVID
To make sure a link correctly transmits packets, the trunk or hybrid ports at the two ends
of the link must have the same PVID.
10—10 Mbps.
100—100 Mbps.
1000—1000 Mbps.
Auto—Autonegotiation.
Auto 10—Autonegotiated to 10 Mbps.
Auto 100—Autonegotiated to 100 Mbps.
Auto 1000—Autonegotiated to 1000 Mbps.
Auto 10 100—Autonegotiated to 10 or 100 Mbps.
Auto 10 1000—Autonegotiated to 10 or 1000 Mbps.
Auto 100 1000—Autonegotiated to 100 or 1000 Mbps.
Auto 10 100 1000—Autonegotiated to 10, 100, or 1000 Mbps.
Auto—Autonegotiation.
Full—Full duplex.
Half—Half duplex.
"Configuring
VLANs."
77
VLANs."