HP 1910 User Manual page 92

Item Description
Set broadcast suppression on the port:
•
•
Broadcast
•
Suppression
Do not configure this item if the storm constrain function for broadcast traffic is enabled on
the port. Otherwise, the suppression result is not determined. To set storm constrain for
broadcast traffic on a port, select Device > Storm Constrain.
Set multicast suppression on the port:
•
•
Multicast
•
Suppression
Do not configure this item if the storm constrain function for multicast traffic is enabled on the
port. Otherwise, the suppression result is not determined. To set storm constrain for multicast
traffic on a port, select Device > Storm Constrain.
Set unicast suppression on the port:
•
•
Unicast
•
Suppression
Do not configure this item if the storm constrain function for unicast traffic is enabled on the
port. Otherwise, the suppression result is not determined. To set storm constrain for unicast
traffic on a port, select Device > Storm Constrain.
Interface or interfaces that you have selected from the chassis front panel and the
aggregate interface list below, for which you have set operation parameters.
Selected Ports
You can set only the state and MAC learning limit for an aggregate interface.
ratio—Sets the maximum percentage of broadcast traffic to the total bandwidth of an
Ethernet port. When you select this option, you must enter a percentage in the box
below.
pps—Sets the maximum number of broadcast packets that can be forwarded on an
Ethernet port per second. When you select this option, you must enter a number in the
box below.
kbps—Sets the maximum number of kilobits of broadcast traffic that can be forwarded
on an Ethernet port per second. When you select this option, you must enter a number
in the box below.
IMPORTANT:
ratio—Sets the maximum percentage of multicast traffic to the total bandwidth of an
Ethernet port. When you select this option, you must enter a percentage in the box
below.
pps—Sets the maximum number of multicast packets that can be forwarded on an
Ethernet port per second. When you select this option, you must enter a number in the
box below.
kbps—Sets the maximum number of kilobits of multicast traffic that can be forwarded
on an Ethernet port per second. When you select this option, you must enter a number
in the box below.
IMPORTANT:
ratio—Sets the maximum percentage of unicast traffic to the total bandwidth of an
Ethernet port. When you select this option, you must enter a percentage in the box
below.
pps—Sets the maximum number of unicast packets that can be forwarded on an
Ethernet port per second. When you select this option, you must enter a number in the
box below.
kbps—Sets the maximum number of kilobits of unicast traffic that can be forwarded on
an Ethernet port per second. When you select this option, you must enter a number in
the box below.
IMPORTANT:
79