Xerox phaser 2135 Advanced Features And Troubleshooting Manual page 97

Troubleshooting
Front Panel Messages (cont'd.)
Supply Fan Error U9
Power Off/On
Temp Sensor Error T29
Power Off/On
Toner Empty
[Black Toner Empty]
[Cyan Toner Empty]
[Magenta Toner Empty]
[Yellow Toner Empty]
Replace Toner
Toner Low
[Black Toner Low]
[Cyan Toner Low]
[Magenta Toner Low]
[Yellow Toner Low]
Top Cover Open
Close Top Cover
Top Output Tray Full
Remove Outputs
Transfer Belt Missing
Reseat Belt
84
Fault An error has been detected with the power supply
cooling fan. Turn off the printer, wait 15 seconds,
then turn on the printer. If the problem persists,
check the support links at:
www.xerox.com/officeprinting/infoSMART.
Fault The temperature sensor is either not communicating
or reporting invalid data. Turn off the printer, wait
15 seconds, then turn on the printer. If the problem
persists, check the support links at:
www.xerox.com/officeprinting/infoSMART.
Fault The toner cartridge has reached its end of life.
Install a new toner cartridge.
Attention The level of toner in the toner cartridge is low, and
should be replaced soon, as it is near its end of life.
Printing can continue until the toner cartridge is
empty; however, some degradation of image quality
may occur. The message will remain until
interrupted by other messages or until the toner
cartridge is replaced.
Fault The Top Cover is open. Close the cover so that
printing can continue.
Fault The top (face down) tray is full, and cannot accept
any more prints until it is emptied. Once emptied,
printing will continue where it left off.
Fault The transfer belt is either missing or must be
reseated to be recognized by the printer. Turn off the
printer, make sure the transfer belt is properly
installed, and turn on the printer. If the problem
persists, install a new transfer belt. For further
assistance, visit the support links at:
www.xerox.com/officeprinting/infoSMART.
Phaser 2135 Color Printer