Xerox phaser 2135 Advanced Features And Troubleshooting Manual page 96

Front Panel Messages (cont'd.)
Replace Drum
[Replace Black Drum]
[Replace Cyan Drum]
[Replace Magenta Drum]
[Replace Yellow Drum]
Replace Fuser
Replace Transfer Belt
RH Sensor Error T30
Power Off/On
Roller Over Temp T31
Power Off/On
Roller Position Error U10
Power Off/On
Toner Missing
[Black Toner Missing U25]
[Cyan Toner Missing U24]
[Magenta Toner Missing U23]
[Yellow Toner Missing U22]
Reseat Toner
Advanced Features and Troubleshooting Manual
Fault The imaging drum has reached its end of life. Install
a new imaging drum.
Fault The fuser has reached its end of life. Install a new
fuser.
Fault The transfer belt has reached its end of life. Install a
new transfer belt.
Fault The relative humidity sensor is either not
communicating or reporting invalid data. Turn off
the printer, wait 15 seconds, then turn on the
printer. If the problem persists, check the support
links at:
www.xerox.com/officeprinting/infoSMART.
Fault The fuser temperature sensor is reporting a
temperature error. Turn off the printer, wait 15
seconds, then turn on the printer. If the problem
persists, install a new fuser. For further assistance,
visit the support links at:
www.xerox.com/officeprinting/infoSMART.
Fault An error has been detected with the fuser error
rollers being in an incorrect position. Turn off the
printer. Pull the green roller release lever, located
on the left side of the printer, forward and then push
backward to return the lever to its home position.
Then turn on the printer. If the problem persists,
check the support links at:
www.xerox.com/officeprinting/infoSMART.
Fault The toner is either missing or must be reseated to be
recognized by the printer. Turn off the printer, wait
15 seconds, then turn on the printer. If the problem
persists, check the support links at:
www.xerox.com/officeprinting/infoSMART.
Troubleshooting
83