Xerox phaser 2135 Advanced Features And Troubleshooting Manual page 102

Printer Management Status Messages (cont'd.)
Jn-Toner Empty
[J9-Yellow Toner Empty]
[J10-Magenta Toner Empty]
[J11-Cyan Toner Empty]
[J12-Black Toner Empty]
Load Size, Type, Tray #
T1-Fuser Upper Error
T2-Fuser Lower Error
T29-Temp Sensor Error
T30-RH Sensor Error
T31-Roller Over Temp
T32-LED Over Temperature
Advanced Features and Troubleshooting Manual
Fault The toner cartridge has reached its end of life.
Install a new toner cartridge.
Fault The specified paper size and type requested by the
print job is not available in the specified tray.
Load the specified paper or press Enter to print
from the tray regardless of what paper size and
type is loaded.
Fault An error in the upper fuser Thermistor was
discovered. Verify that the clearances around the
printer are consistent with the recommendations
in the User safety summary. Turn off the printer,
wait 15 seconds, then turn on the printer. If the
problem persists, install a new fuser. For further
assistance, visit the support links at:
www.xerox.com/officeprinting/infoSMART.
Fault An error in the lower fuser Thermistor was
discovered. Turn off the printer, wait 15 seconds,
then turn on the printer. If the problem persists,
install a new fuser. For further assistance, visit the
support links at:
www.xerox.com/officeprinting/infoSMART.
Fault The temperature sensor is either not
communicating or reporting invalid data. To reset
the sensor, open and close the Top Cover. If the
problem persists, check the support links at:
www.xerox.com/officeprinting/infoSMART.
Fault The relative humidity sensor is either not
communicating or reporting invalid data. Turn off
the printer, wait 15 seconds, then turn on the
printer. If the problem persists, check the support
links at:
www.xerox.com/officeprinting/infoSMART.
Fault The fuser temperature sensor is reporting a
temperature error. Turn off the printer, wait 15
seconds, then turn on the printer. If the problem
persists, install a new fuser. For further assistance,
visit the support links at:
www.xerox.com/officeprinting/infoSMART.
Fault One of the LED bars is reporting a temperature
error. Turn off the printer, wait 15 seconds, then
turn on the printer. If the problem persists, check
the support links at:
www.xerox.com/officeprinting/infoSMART.
Troubleshooting
89