Xerox phaser 2135 Advanced Features And Troubleshooting Manual page 141

Networking
Step-by-Step Setup for IBM TCP/IP for OS/2
TCP/IP Protocol Configuration
1. Acquire two IP addresses for use on your server and your Phaser 2135 printer.
2. Install TCP/IP for OS/2. Remember to open LAN Adapter and Protocol Support
(LAPS/MPTS, etc.) and configure the TCP/IP protocol for your network adapter. (See
your OS/2 documentation for configuring network adapters for the TCP/IP protocol.)
3. Open (double-click) TCP/IP Configuration Object.
Click the Printing tab and enter the following:
I
REMOTE PRINT SERVER = Printer IP Address in 32-bit dotted decimal notation
I
(e.g., 127.0.0.0).
REMOTE PRINT SERVER'S PRINTER = ps (Enter ps without quotes and in
I
lowercase.)
MAXIMUM NUMBER OF LPD PORTS = Enter a number between 2 and 64
I
inclusive.
FOR OS/2 PRINTING ONLY (NO WIN-OS/2) Click the Autostart tab. Highlight
I
lprportd, then click Autostart Service, Foreground Session and Minimized.
Close the TCP/IP Configuration Windows. Click SAVE, then reply YES to Update
I
CONFIG.SYS.
Shutdown your server/workstation and reboot.
I
Note
Once completed and you have rebooted, use the "ping" command at an OS/2
Command Prompt to ping your server/workstation's IP address. Repeat the ping
command using your Phaser 2135 printer's IP Address to confirm that your
printer is configured properly for using TCP/IP.
128 Phaser Color Printer 2135