Xerox phaser 2135 Advanced Features And Troubleshooting Manual page 122

Setting Default Gateway at the Front Panel
Note
Setting a Default Gateway can also be accomplished in CentreWare DP,
CentreWare MC, or CentreWare IS. Refer to page 69 for more information.
1. Press Menu Up or Menu Down until you see:
2. Press Item Up or Item Down until you see:
3. Press Value Up or Value Down. You should see:
4. Press Value Up or Value Down to change the value of the character above the cursor.
The value is incremented or decremented by 1 each time the key is pressed. Holding
down Value Up or Value Down causes continuous scrolling through the values.
5. To change other characters in the Default Gateway address, press Item Up or Item
Down to scroll right or left respectively through the character string, then press Value
Up or Value Down to change the value of the character above the cursor (as in Step 4).
6. When you have completed setting the Default Gateway address, press Enter. You
should see:
7. Press On Line. You should see:
Advanced Features and Troubleshooting Manual
Menus
Ethernet Menu
Ethernet Menu
Default Gateway
Default Gateway =
xxx.xxx.xxx.xxx
Ethernet Menu
Default Gateway
Ready
Networking
109