Xerox phaser 2135 Advanced Features And Troubleshooting Manual page 135

Networking
Step-by-Step Setup (AppleTalk)
Configuring EtherTalk at the Front Panel
To enable the EtherTalk protocol at your printer's Front Panel, follow these steps:
1. Press Menu Up or Menu Down until you see:
2. Press Item Up or Item Down until you see:
3. Press Value Up or Value Down. You should see:
4. Press Enter. You should see:
5. Press On Line. You should see:
6. Restart the printer.
Selecting the Printer from the Chooser
Before you send a print job to the Phaser 2135 printer, make sure that it is selected as the
current printer in the Chooser.
1. At the printer, print a Configuration Page and note the EtherTalk Name. Refer to the
Phaser 2135 Color Printer Quick Network Install Guide for instructions.
2.
At your computer, select the APPLE in the upper left corner of the Desktop.
3. Select the Chooser entry in the menu.
4. Make sure that AppleTalk is active.
122
Menus
Ethernet Menu
Ethernet Menu
EtherTalk Enable
EtherTalk Enable
On
Ethernet Menu
EtherTalk Enable
Ready
Phaser Color Printer 2135