Xerox phaser 2135 Advanced Features And Troubleshooting Manual page 92

Front Panel Messages (cont'd.)
Disk Read [Write] Error
Press Enter To Clear
Drum Error
[Black Drum Error U29]
[Cyan Drum Error U28]
[Magenta Drum Error U27]
[Yellow Drum Error U26]
Reseat Drum
Imaging Drum Missing
[Black Imaging Drum Missing]
[Cyan Imaging Drum Missing]
[Magenta Imaging Drum
Missing]
[Yellow Imaging Drum
Missing]
Reseat Drum
Drum
[Black Drum]
[Cyan Drum]
[Magenta Drum]
[Yellow Drum]
Near End Of Life
Duplex I/F Error U12
Power Off/On
Engine Control Error U5
Power Off/On
Engine EPROM Error U2
Power Off/On
Advanced Features and Troubleshooting Manual
Attention There was a hard disk read error that prevented the
data from being read. Press the Enter button to clear
the message. Turn off the printer, wait 15 seconds,
then turn on the printer. If the problem persists,
check the support links at:
www.xerox.com/officeprinting/infoSMART.
Fault The imaging drum is either missing or must be
reseated to be recognized by the printer. Turn off the
printer, make sure the imaging drum is properly
installed, then turn on the printer. If the problem
persists, replace the corresponding imaging drum. If
you need more help, check the support links at:
www.xerox.com/officeprinting/infoSMART.
Fault The imaging drum is either missing or must be
reseated to be recognized by the printer. Turn off the
printer, make sure the imaging drum is properly
installed, then turn on the printer. If the problem
persists, install a new imaging drum. For further
assistance, visit the support links at:
www.xerox.com/officeprinting/infoSMART.
Attention The imaging drum is near its end of life. Printing
can continue until the printer determines that the
imaging drum is at its end of life, however some
degradation of image quality may occur. The
message will remain until interrupted by other
messages or until the imaging drum is replaced.
Fault An error has been detected with the duplex module
interface and communication path. Turn off the
printer, wait 15 seconds, then turn on the printer. If
the problem persists, be sure the duplex unit is
properly installed. If you need more help, check the
support links at:
www.xerox.com/officeprinting/infoSMART.
Fault During the printer's self-diagnostics there was a
problem with the internal control logic. Turn off the
printer, wait 15 seconds, then turn on the printer. If
the problem persists, check the support links at:
www.xerox.com/officeprinting/infoSMART.
Fault During the printer's self-diagnostics there was a
problem reading the engine EPROM. Turn off the
printer, wait 15 seconds, then turn on the printer. If
the problem persists, check the support links at:
www.xerox.com/officeprinting/infoSMART.
Troubleshooting
79