Ricoh Pro 8100s User Manual page 207

Messages
"Could not send the data
because the PC timed out
before it was sent."
When documents cannot be stored on a memory storage device
Messages
"Cannot write on the memory
storage device because
remaining free space is
insufficient."
"Cannot write on the memory
storage device because the
device is write-protected."
Messages Displayed When Using the Scanner Function
Causes
A time out occurred when using
WSD Scanner. Time outs occur
when too much time passes
between scanning an original
and sending its data. The
followings are likely causes of
time outs:
• Too many originals per set.
• Misfed originals.
• Transmission of other jobs.
Causes
• The memory storage
device is full and scan data
cannot be saved.
• Even if the memory storage
device appears to have
sufficient free space, data
might not be saved if the
maximum number of files
that can be saved is
exceeded.
The memory storage device is
write-protected.
Solutions
• Reduce the number of
originals, and then scan
again.
• Remove any misfed
original, and then scan
again.
• Use Scanner Journal to
check there are no jobs
awaiting transmission, and
then scan again.
Solutions
• Replace the memory
storage device.
• If the document is scanned
as single-page or divided
multiple pages, data
already written to the
memory storage device is
saved as is. Replace the
memory storage device,
and then press [Retry] to
save the remaining data,
or press [Cancel] to redo
the scan.
Unlock the write-protection on
the memory storage device.
199