Ricoh Pro 8100s User Manual page 182

9. Troubleshooting
Messages
"Hardware Problem: Wireless
Card"
(A "wireless LAN board" or
"Bluetooth interface unit" is
referred to as a "wireless card".)
"Hardware Problem: Wireless
Card"
(A "wireless LAN board" or
"Bluetooth interface unit" is
referred to as a "wireless card".)
"Load following paper in n. To
force print, select another tray
and press [Continue]."
(A figure is placed at n.)
"Paper in staple tray. Open
cover and remove paper."
174
Causes
The wireless LAN board can be
accessed, but an error was
detected.
• The Bluetooth interface unit
was connected while the
machine was turned on.
• The Bluetooth interface unit
was removed while the
machine was turned on.
The printer driver settings are
incorrect or the tray does not
contain paper of the size
selected in the printer driver.
If printing is stopped before it is
finished, paper may remain in
the finisher.
Solutions
Turn off the power, and then
confirm the wireless LAN board
is inserted correctly. After
confirmation, turn on the power
again. If the message appears
again, contact your service
representative.
Turn off the power, and then
confirm the Bluetooth interface
unit is inserted correctly. After
confirmation, turn on the power
again. If the message appears
again, contact your service
representative.
Check that the printer driver
settings are correct, and then
load paper of the size selected
in the printer driver into the input
tray. For details about how to
change the paper size, see
"Changing the Paper Size",
Paper Specifications and
Adding Paper .
Remove the paper remaining in
the finisher.