Ricoh Pro 8100s User Manual page 202

9. Troubleshooting
Messages
"Not all of the image will be
scanned."
"Not all of the image will be
scanned."
"The size of the scanned data is
too small."
"Check the resolution and the
ratio and then press the Start
key again."
194
Causes
If the scaling factor specified in
"Specify Reproduction Ratio" is
too large, part of the image
may be lost.
Using [Specify Size] to scale
down a large document may
cause part of the image to be
lost.
The data being scanned is too
small for the scale ratio
specified in [Specify Size].
Solutions
• Reduce the scaling factor
in "Specify Reproduction
Ratio", and then try to scan
the original again.
• If displaying the entire
image is not necessary,
press the [Start] key to start
scanning with the current
scaling factor.
• Specify a large size in
[Specify Size], and then try
to scan the original again.
• If displaying the entire
image is not necessary,
press the [Start] key to start
scanning with the current
scaling factor.
Specify a higher resolution or a
large size in [Specify Size], and
then try to scan the original
again.