Displaying Interface Information - Dell PowerConnect B-RX Configuration Manual

TABLE 136
Message level
Alert
Notification
Notification
Notification
Notification
Notification
Notification

Displaying interface information

To display information about the device's IS-IS interfaces, enter the following command at any level
of the CLI.
BigIron RX Series Configuration Guide
53-1002253-01
IS-IS Syslog messages
Message
ISIS MEMORY USE EXCEEDED
ISIS L1 ADJACENCY DOWN <system-id> on
interface <interface-id>
ISIS L1 ADJACENCY UP <system-id> on
interface <interface-id>
ISIS L2 ADJACENCY DOWN <system-id> on
interface <interface-id>
ISIS L2 ADJACENCY UP <system-id> on
interface <interface-id>
ISIS ENTERED INTO OVERLOAD STATE
ISIS EXITED FROM OVERLOAD STATE
Displaying IPv4 IS-IS information
Explanation
IS-IS is requesting more memory than is
available.
The device's adjacency with this Level-1 IS
has gone down.
The <system-id> is the system ID of the IS.
The <interface-id> is the ID of the interface
over which the adjacency was established.
The device's adjacency with this Level-1 IS
has come up.
The <system-id> is the system ID of the IS.
The <interface-id> is the ID of the interface
over which the adjacency was established.
The device's adjacency with this Level-2 IS
has gone down.
The <system-id> is the system ID of the IS.
The <interface-id> is the ID of the interface
over which the adjacency was established.
The device's adjacency with this Level-2 IS
has come up.
The <system-id> is the system ID of the IS.
The <interface-id> is the ID of the interface
over which the adjacency was established.
The device has set the overload bit to (1),
indicating that the device's IS-IS resources
are overloaded.
The device has set the overload bit to off (0),
indicating that the device's IS-IS resources
are no longer overloaded.
28
893