Topology - Dell PowerConnect B-RX Configuration Manual
Bigiron rx series configuration guide v02.8.00
Hide thumbs
Also See for PowerConnect B-RX:
- Configuration manual (1436 pages) ,
- Getting started manual (32 pages) ,
- Installation manual (240 pages)
Table of Contents
Advertisement
Commands
show default values
show logging
show sntp associations
show sntp status
show terminal
snmp-server contact <string>
snmp-server enable traps
<trap-type>
snmp-server enable traps holddown-time <secs>
snmp-server host <ip-addr> [0 | 1] <string> [port <value>]
snmp-server location <string>
snmp-server trap-source loopback <num> | ethernet
<slot/port> | ve <num>
sntp poll-interval <1-65535>
sntp server <ip-addr> | <hostname> [<version>]
static-mac-address <mac-addr> ethernet <portnum> [to
<portnum> ethernet <portnum>]
[priority <number>] [host-type | router-type | fixed-host]
system-max ip-static-route <num>
system-max subnet-per-interface <num>
system-max subnet-per-system <num>
terminal length <number-of-lines>
unknown-unicast limit <number>
Topology
Commands
master-vlan <vlan-id>
member-group <num>
BigIron RX Series Configuration Guide
53-1002253-01
Topology
See ...
"Displaying and modifying system parameter default
settings"
on page 130
"Examples of Syslog messages for CLI access"
page 121
"Specifying a Simple Network Time Protocol (SNTP)
server"
on page 124
"Specifying a Simple Network Time Protocol (SNTP)
server"
on page 124
"Checking the length of terminal displays"
page 129
"Entering system administration information"
page 117
"Disabling SNMP traps"
on page 120
"Setting the SNMP Trap holddown time"
"Specifying an SNMP trap receiver"
"Entering system administration information"
page 117
"Specifying a Single trap source"
"Specifying a Simple Network Time Protocol (SNTP)
server"
on page 124
"Specifying a Simple Network Time Protocol (SNTP)
server"
on page 124
"Assigning static MAC address entries to priority
queues"
on page 481
"Displaying and modifying system parameter default
settings"
on page 130
"Displaying and modifying system parameter default
settings"
on page 130
"Displaying and modifying system parameter default
settings"
on page 130
"Configuring terminal display"
"NP based multicast, broadcast, and
unknown-unicast rate limiting"
See ...
"Configuring a topology group"
"Configuring a topology group"
E
on
on
on
on page 119
on page 118
on
on page 119
on page 129
on page 513
on page 449
on page 449
1377
Advertisement
Table of Contents
