Dell PowerConnect B-RX Configuration Manual page 1059

TABLE 160
This field...
PAE Capability
system-auth-control
Number of ports enabled
re-authentication
global-filter-strict-security
global-filter-strict-security:
quiet-period
tx-period
supp-timeout
server-timeout
max-req
re-authperiod
security-hold-time
Protocol Version
Auth-fail-action
BigIron RX Series Configuration Guide
53-1002253-01
Output from the show dot1x command
Displays...
The Port Access Entity (PAE) role for the BigIron RX device. This is always
"Authenticator Only".
Whether system authentication control is enabled on the device. The
dot1x-enable command enables system authentication control on the
device.
Number of interfaces on the devices that have been enabled for 802.1x.
Whether periodic re-authentication is enabled on the device. Refer to
"Configuring periodic re-authentication"
When periodic re-authentication is enabled, the device automatically
re-authenticates Clients every 3,600 seconds by default.
Whether or not strict security mode is enabled globally.
Whether strict security mode is enabled or disabled globally. See
"Disabling and enabling strict security mode for dynamic filter
assignment"
When the BigIron RX is unable to authenticate a Client, the amount of
time the BigIron RX waits before trying again (default 60 seconds).
Refer to
change this setting.
When a Client does not send back an EAP-response/identity frame, the
amount of time the BigIron RX waits before retransmitting the
EAP-request/identity frame to a Client (default 30 seconds).
Refer to
frames"
When a Client does not respond to an EAP-request frame, the amount of
time before the BigIron RX retransmits the frame.
Refer to
to the client"
When the Authentication Server does not respond to a message sent
from the Client, the amount of time before the BigIron RX retransmits
the message.
Refer to
authentication server"
this setting.
The number of times the BigIron RX retransmits an EAP-request/identity
frame if it does not receive an EAP-response/identity frame from a Client
(default 2 times).
Refer to
retransmissions"
setting.
How often the device automatically re-authenticates Clients when
periodic re-authentication is enabled (default 3,600 seconds).
Refer to
information on how to change this setting.
This field is not supported.
The version of the 802.1x protocol in use on the device.
The configured authentication-failure action. This can be Restricted
VLAN or Block Traffic.
Displaying 802.1x information
on page 973.
"Setting the quiet period" on page 979 for information on how to
"Setting the interval for retransmission of EAP-request/ identity
on page 979 for information on how to change this setting.
"Specifying a timeout for retransmission of EAP-request frames
on page 980 for information on how to change this setting.
"Specifying a timeout for retransmission of messages to the
on page 980 for information on how to change
"Specifying the number of EAP-request/identity frame
on page 979 for information on how to change this
"Configuring periodic re-authentication"
33
on page 978.
on page 978 for
983