•
Disabling or reenabling event logging
OSPFv3 does not currently support the generation of SNMP traps. Instead, you can disable or
re-enable the logging of OSPFv3-related events such as neighbor state changes and database
overflow conditions. By default, the Brocade device logs these events.
To disable the logging of events, enter the following command.
BigIron RX(config-ospf6-router)# no log-status-change
Syntax: [no] log-status-change
To re-enable the logging of events, enter the following command.
BigIron RX(config-ospf6-router)# log-status-change
Displaying OSPFv3 information
You can display the information for the following OSPFv3 parameters:
•
•
•
•
•
•
•
•
•
•
Displaying OSPFv3 area information
To display global OSPFv3 area information for the Brocade device, enter the following command at
any CLI level.
BigIron RX Series Configuration Guide
53-1002253-01
Transmit-delay: The time it takes to transmit Link State Update packets on this interface. The
command syntax is ipv6 ospf transmit-delay <seconds>. The value can be from 0 – 3600
seconds. The default is 1 second.
Areas
Link state databases
Interfaces
Memory usage
Neighbors
Redistributed routes
Routes
SPF
Virtual links
Virtual neighbors
Displaying OSPFv3 information
48
1227