Displaying 802.1X Statistics - Dell PowerConnect B-RX Configuration Manual

Bigiron rx series configuration guide v02.8.00
Hide thumbs Also See for PowerConnect B-RX:
Table of Contents

Advertisement

33
Displaying 802.1x information
TABLE 160
This field...
Mac Session Aging
Mac Session max-age
Maximum Failed Attempts
To display information about the 802.1x configuration on an individual port, enter a command such
as the following.
BigIron RX# show dot1x config e 1/3
Port 1/3 Configuration:
AuthControlledPortControl
max-clients
multiple-clients
filter-strict-security
Syntax: show dot1x config ethernet <slot/port>
The following additional information is displayed in the show dot1x config command for an
interface.
TABLE 161
This field...
AuthControlledPortControl
multiple-hosts
max-clients
multiple-clients
filter-strict-security
filter-strict-security:

Displaying 802.1x statistics

To display 802.1x statistics for an individual port, enter a command such as the following.
984
Output from the show dot1x command (Continued)
Displays...
Whether aging for dot1x-mac-sessions has been enabled or disabled for
permitted or denied dot1x-mac-sessions.
The configured software aging time for dot1x-mac-sessions.
The number of failed authentication attempts, if the
authentication-failure action shows Restricted VLAN,
: Auto
: 32
: Enable
: Enable
Output from the show dot1x config command for an interface
Displays...
The port control type configured for the interface. If set to auto,
authentication is activated on the 802.1x-enabled interface.
Whether the port is configured to allow multiple Supplicants accessing
the interface on the BigIron RX through a hub.
Refer to
for information on how to change this setting.
The maximum number of clients that can be authenticated on this
interface.
Shows if the interface is enabled or disabled for multiple client
authentication.
Shows if the interface is enabled or disabled for strict security mode.
Whether strict security mode is enabled or disabled for the interface.
See
assignment"
"Allowing multiple 802.1x clients to authenticate"
"Disabling and enabling strict security mode for dynamic filter
on page 973.
on page 980
BigIron RX Series Configuration Guide
53-1002253-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bigiron rx series

Table of Contents