Displaying Bgp4+ Peer Group Configuration Information - Dell PowerConnect B-RX Configuration Manual

TABLE 207
This field...
NLRIs Discarded due to
Routes Advertised
NLRIs Sent in Update Message
Peer Out of Memory Count for

Displaying BGP4+ peer group configuration information

You can display configuration information for all peer groups or a specified peer group configured
on a switch.
For example, to display configuration information for a peer group named peer1, enter the following
command at any level of the CLI.
BigIron RX Series Configuration Guide
53-1002253-01
BGP4+ neighbor route summary information (Continued)
Displays...
Indicates the number of times the switch discarded an NLRI for the
neighbor due to the following reasons:
•
•
•
•
•
The number of routes the switch has advertised to this neighbor.
•
•
The number of NLRIs for new routes the switch has sent to this neighbor
in UPDATE messages.
•
•
Statistics for the times the switch has run out of BGP4+ memory for the
neighbor during the current BGP4+ session.
•
•
•
•
•
Displaying BGP4+ information
Maximum Prefix Limit – The switch's configured maximum prefix
amount had been reached.
AS Loop – An AS loop occurred. An AS loop occurs when the BGP4+
AS-path attribute contains the local AS number.
Invalid Nexthop Address – The next hop value was not acceptable.
Duplicated Originator_ID – The originator ID was the same as the
local switch ID.
Cluster_ID – The cluster list contained the local cluster ID, or
contained the local switch ID (see above) if the cluster ID is not
configured.
To be Sent – The number of routes the switch has queued to send
to this neighbor.
To be Withdrawn – The number of NLRIs for withdrawing routes the
switch has queued up to send to this neighbor in UPDATE
messages.
Withdraws – The number of routes the switch has sent to the
neighbor to withdraw.
Replacements – The number of routes the switch has sent to the
neighbor to replace routes the neighbor already has.
Receiving Update Messages – The number of times UPDATE
messages were discarded because there was no memory for
attribute entries.
Accepting Routes(NLRI) – The number of NLRIs discarded because
there was no memory for NLRI entries. This count is not included in
the Receiving Update Messages count.
Attributes – The number of times there was no memory for BGP4+
attribute entries.
Outbound Routes (RIB-out) – The number of times there was no
memory to place a "best" route into the neighbor's route
information base (Adj-RIB-Out) for routes to be advertised.
Outbound Routes Holder – For debugging purposes only.
45
1183