Metro Ring Protocol - Dell PowerConnect B-RX Configuration Manual

Commands
show ip route summary
show ip static-arp [ethernet <portnum> | mac-address
<xxxx.xxxx.xxxx> [<mask>] |
<ip-addr> [<ip-mask>]] [<num>] [| begin<expression> |
exclude<expression> | include<expression> ]
show ip traffic
system-max ip-static-arp <num>
traceroute <host-ip-addr> [maxttl <value>] [minttl
<value>] [numeric] [timeout <value>] [source-ip <ip
addr>]

Metro Ring protocol

Commands
metro-ring <ring-id>
name <string>
master
ring-interface ethernet <primary-if> ethernet
<secondary-if>
enable
hello-time <ms>
preforwarding-time <ms>
diagnostics
show metro <ring-id> diag
show topology-group [<group-id>]
show metro [<ring-id>]
BigIron RX Series Configuration Guide
53-1002253-01
Metro Ring protocol
See ...
"Displaying the IP route table"
"Displaying the static ARP table"
"Displaying IP traffic statistics"
"Changing the maximum number of entries the static
ARP table can hold" on page 191
"Using a DNS name to initiate a trace route"
page 178
See ...
"Configuring MRP with shared interfaces"
page 417
"Configuring MRP with shared interfaces"
page 417
"Adding an MRP ring to a VLAN"
"Adding an MRP ring to a VLAN"
"Configuring MRP with shared interfaces"
page 417
"Changing the hello and preforwarding times"
page 412
"Changing the hello and preforwarding times"
page 412
"Enabling MRP diagnostics" on page 418
"Displaying MRP diagnostics"
"Displaying ring information" on page 420
"Displaying topology group information"
"Displaying ring information" on page 420
E
on page 228
on page 226
on page 231
on
on
on
on page 411
on page 411
on
on
on
on page 419
on page 419
1341