Displaying Ospfv3 Database Information - Dell PowerConnect B-RX Configuration Manual

48
Displaying OSPFv3 information
BigIron RX# show ipv6 ospf area
Area 0:
Interface attached to this area: loopback 2 ethe 3/2 tunnel 2
Number of Area scoped LSAs is 6
Statistics of Area 0:
...
Syntax: show ipv6 ospf area [<area-id>]
You can specify the <area-id> parameter in the following formats:
•
•
The <area-id> parameter restricts the display to the specified OSPF area
This display shows the following information.
TABLE 211
This field...
Area
Interface attached to this area
Number of Area scoped LSAs
SPF algorithm executed
SPF last updated
Current SPF node count
Router
Network
Indx
Area
Maximum hop count to nodes.

Displaying OSPFv3 database Information

You can display a summary of the Brocade device's link state database or detailed information
about a specified LSA type.
To display a summary of a device's link state database, enter the following command at any CLI
level.
1228
SPF algorithm executed 16 times
SPF last updated: 335256 sec ago
Current SPF node count: 3
Router: 2 Network: 1
Maximum of Hop count to nodes: 2
As an IPv4 address, for example, 192.168.1.1
As a numerical value from 0 – 2,147,483,647
OSPFv3 area information fields
Displays...
The area number.
The router interfaces attached to the area.
Number of LSAs with a scope of the specified area.
The number of times the OSPF Shortest Path First (SPF) algorithm is executed
within the area.
The interval in seconds that the SPF algorithm was last executed within the
area.
The current number of SPF nodes in the area.
Number of router LSAs in the area.
Number of network LSAs in the area.
The row number of the entry in the router's OSPF area table.
The area number.
The maximum number of hop counts to an SPF node within the area.
BigIron RX Series Configuration Guide
53-1002253-01