Displaying The Engine Id; Displaying Snmp Groups - Dell PowerConnect B-RX Configuration Manual

The priv [encrypted] des <des-password> parameter is optional after you enter the md5 or sha
password. The priv parameter defines the type of encryption that will be used to encrypt the
privacy password. If the "encryption" keyword is used, enter a 16-octet DES key in hexadecimal
format for the des-password. If the "encryption" keyword is not used, enter a password string of at
least 8 characters. The agent will generate a suitable 16-octet DES key from the password string:
•
•

Displaying the engine ID

To display the engine ID of a management module, enter a command such as the following.
BigIron RX(config)# show snmp engineid
Local SNMP Engine ID: 800007c70300e05290ab60
Engine Boots: 3
Engine time: 5
Syntax: show snmp engineid
The engine ID identifies the source or destination of the packet.
The engine boots represents the number of times that the SNMP engine reinitialized itself with the
same engine ID. If the engineID is modified, the boot count is reset to 0.
The engine time represents the current time with the SNMP agent.

Displaying SNMP groups

To display the definition of an SNMP group, enter a command such as the following.
BigIron RX(config)# show snmp group
groupname = exceptifgrp
security model = v3
security level = authNoPriv
ACL id = 2
readview = exceptif
writeview = <none>
Syntax: show snmp group
The value for security level can be one of the following.
Security level
<none>
noauthNoPriv
authNoPriv
BigIron RX Series Configuration Guide
53-1002253-01
If DES is the privacy protocol to be used, enter des followed by a 16-octet DES key in
hexadecimal format for the <des-password-key>. If you include the encrypted keyword, enter a
password string of at least 8 characters.
If AES is the privacy protocol to be used, enter aes followed by the AES password key. For a
small password key, enter 12 characters. For a big password key, enter 16 characters. If you
include the encrypted keyword, enter a password string containing 32 hexadecimal characters.
Configuring your NMS
Authentication
If the security model shows v1 or v2, then security level
is blank. User names are not used to authenticate
users; community strings are used instead.
Displays if the security model shows v3 and user
authentication is by user name only.
Displays if the security model shows v3 and user
authentication is by user name and the MD5 or SHA
algorithm.
36
1019