Dell PowerConnect B-RX Configuration Manual page 546

17
Displaying VRRP and VRRPE information
The brief parameter displays summary information. Refer to
page 467.
The ethernet <slot>/<portnum> parameter specifies an Ethernet port. If you use this parameter,
the command displays VRRP or VRRPE information only for the specified port.
The ve <num> parameter specifies a virtual interface. If you use this parameter, the command
displays VRRP or VRRPE information only for the specified virtual interface.
The statistic parameter displays statistics. Refer to
This display shows the following information.
TABLE 90
This field...
Total number of VRRP (or
VRRP-Extended) routers defined
Interface parameters
Interface
auth-type
Virtual router parameters
VRID
state
administrative-status
mode
virtual MAC
470
CLI display of VRRP or VRRPE detailed information
Displays...
The total number of virtual routers configured on this BigIron RX.
NOTE: The total applies only to the protocol the BigIron RX is running.
The interface on which VRRP or VRRPE is configured. If VRRP or VRRPE
is configured on multiple interfaces, information for each interface is
listed separately.
The authentication type enabled on the interface.
The virtual router configured on this interface. If multiple virtual routers
are configured on the interface, information for each virtual router is
listed separately.
This BigIron RX's VRRP or VRRPE state for the virtual router. The state
can be one of the following:
•
NOTE: If the state is "initialize" and the mode is incomplete, make sure
•
•
The administrative status of the virtual router. The administrative status
can be one of the following:
•
•
Indicates whether the BigIron RX is the Owner or a Backup for the virtual
router.
NOTE: If "incomplete" appears after the mode, configuration for this
The virtual IP MAC address that this virtual router is backing up.
"Displaying summary information"
"Displaying statistics"
For example, if the BigIron RX is running VRRPE, the total applies
only to VRRPE routers.
initialize – The virtual router is not enabled (activated). If the state
remains "initialize" after you activate the virtual router, make sure
that the virtual router is also configured on the other routers and
that the routers can communicate with each other.
you have specified the IP address for the virtual router.
backup – This BigIron RX is a Backup for the virtual router.
master – This BigIron RX is the Master for the virtual router.
disabled – The virtual router is configured on the interface but
VRRP or VRRPE has not been activated on the interface.
enabled – VRRP or VRRPE has been activated on the interface.
virtual router is incomplete. For example, you might not have
configured the virtual IP address that is being backup up by the
virtual router.
This field applies only to VRRP. All BigIron RX devices configured
for VRRPE are Backups.
on page 472.
BigIron RX Series Configuration Guide
53-1002253-01
on