Dynamically Applying Existing Acls Or Mac Address Filter - Dell PowerConnect B-RX Configuration Manual

Dynamically applying existing ACLs or MAC address filter

When a port is authenticated using 802.1x security, an IP ACL or MAC address filter that exists in
the running configuration on the BigIron RX can be dynamically applied to the port. To do this, you
configure the Filter-ID (type 11) attribute on the RADIUS server. The Filter-ID attribute specifies the
name or number of the Brocade IP ACL or MAC address filter.
The following is the syntax for configuring the Filter-ID attribute to refer to a Brocade IP ACL or MAC
address filter.
Value
ip.<number>.in
ip.<name>.in
mac.<number>.in
The following table lists examples of values you can assign to the Filter-ID attribute on the RADIUS
server to refer to IP ACLs and MAC address filters configured on a BigIron RX.
Possible values for the filter ID attribute on the
RADIUS server
ip.2.in
ip.102.in
ip.fdry_filter.in
mac.401.in
mac.402.in
mac.403.in
NOTES:
BigIron RX Series Configuration Guide
53-1002253-01
Description
Applies the specified numbered ACL to the 802.1x
authenticated port in the inbound direction.
Applies the specified named ACL to the 802.1x authenticated
port in the inbound direction.
Applies the specified numbered MAC address filter to the
802.1x authenticated port in the inbound direction.
•
The <name> in the Filter ID attribute is case-sensitive.
•
You can specify only numbered MAC address filters in the Filter ID attribute. Named
MAC address filters are not supported.
•
Dynamic ACL filters are supported only for the inbound direction. Dynamic outbound
ACL filters are not supported.
•
MAC address filters are supported only for the inbound direction. Outbound MAC
address filters are not supported.
•
Dynamically assigned IP ACLs and MAC address filters are subject to the same
configuration restrictions as non-dynamically assigned IP ACLs and MAC address
filters.
Configuring 802.1x port security
ACL or MAC address filter configured on the BigIron RX device
access-list 2 permit host 36.48.0.3
access-list 2 permit 36.0.0.0 0.255.255.255
access-list 102 permit ip 36.0.0.0 0.255.255.255 any
ip access-list standard fdry_filter
permit host 36.48.0.3
access-list 401 permit 3333.3333.3333 ffff.ffff.ffff any etype eq
0800
access-list 402 permit 3333.3333.3333 ffff.ffff.ffff any etype eq
0800
access-list 403 permit 2222.2222.2222 ffff.ffff.ffff any etype eq
0800
33
975