Mirroring Ports; Supported Acls; Configuring Qos For The 16 X 10G Module - Dell PowerConnect B-RX Configuration Manual

18
Configuring multicast traffic engineering
Table 99
independent flag.
TABLE 99
Qos profile
Low priority DP1
Low priority DP1
Low priority DP1
Low priority DP0
Low priority DP0
High priority DP1
High priority DP1
High priority DP1
High priority DP0

Mirroring ports

The 16x 10GE module supports mirroring, but with the following limitations:
•
•
•
•

Supported ACLs

The 16x10GE module supports standard, extended, named and numbered egress ACLs. Refer to
Chapter 21, "Access Control List"

Configuring QoS for the 16 x 10G module

New CLI commands have been added to allow alternating between server and storage modes on
the 10 x 16GE module. The new commands are part of the qos group, and configured at the
interface level.
Configuration steps
1. To set the group port 1 weight, low prioriy traffic,
2. To set the group port 1 weight, high prioriy traffic,
502
identifies the profile used for network control traffic which is identified using an
QOS profile index
QOS profile index (depending
on network port)
0,1,2,3
0,1,2,3
0,1,2,3
4,5,6,7
4,5,6,7
8,9,10,11
8,9,10,11
8,9,10,11
12,13,14,15
A 16X10GE port cannot be configured as mirror port.
Only one port can be monitored at any time from ports 1 - 8, and one port can also be
monitored at any time from ports 9 - 16.
The mirror port for ingress or egress should be the same port, they cannot be monitored on
multiple separate mirror ports.
Mirror(analyzer) ports cannot be assigned to the 16x10GE module. You can monitor traffic on
16x10 ports.
BigIron RX(config-if-e10000-4/1)#qos rcv-scheduler wfq 1
BigIron RX(config-if-e10000-4/1)#qos rcv-scheduler wfq 1 2
Comments
Only used for control
traffic
for additional information.
BigIron RX Series Configuration Guide
53-1002253-01