Vodavi Starplus Triad-S Product Description Manual page 191

5-60
At an idle station:
1. Dial the Keyset Mode code [648] on the dial pad,
2. Press [
3. Press [#] to scroll through the baud rates.
4. Press the HOLD button to save the desired entries.
Conditions
ATH or ATHX (X = 0 or 1) -- This is the modem on hook/off hook
command. ATH or ATH0 forces the telephone to the on hook state
from its current state. ATH1 forces the telephone to the off hook state
from its current state.
If the handsetis off hook (lifted),these commands are discarded and
no action is taken by the telephone.
CKTU -- This mode is used when the optional Wanderer (cordless key
telephone unit) is connected to the station. (Refer to the Wanderer
User Guide for additional information.)
The KSU system software version must be 1.34 or greater for
Wanderer operation. Version 1.3 can be obtained from the Sales
department.
-or-
Press pre-programmed KEYSET MODE button, the following displays:
IN ACTI VE
MOD E= ✳
] to scroll through the keyset modes.
✳
The telephone must be in the AT command mode to process AT
commands.
All CTI information is still sent out the RS232 port in the AT command
mode.
The ATD command is always accepted by the telephone while it is in
the AT command mode. ATHX is accepted only if enabled.
ATZ is always enabled if station is in the ATD or ATH command mode.
ATD accepts W to indicate a pause command (ATDT9W9982200).
S AV E =H OLD BA UD =#
Keyset Mode