5-30
Removing Follow-Me Call Forwarding (off-site location)
1. Dial into the system on a DISA or TIE trunk. Enter the DISA access
2. Dial the Follow-Me Forward code [642] on the dial pad.
3. Dial the station number of the station that forwarding is to be
4. Dial [6] (regardless of the forward condition).
5. Redial the same station number. A confirmation tone sounds; five
Conditions
code, if applicable.
cancelled.
seconds later a dial tone is received.
If a Call Forward mode is currently active at the station where
forwarding is desired, the new forward becomes active and cancels
the previous forward.
Both internal and external calls to the affected station forward to the
designated location.
Call forwarding must be allowed in programming for the affected
station.
When remote forward is activated, the forwarding is immediate.
A station' s Call Forward status is stored in a battery protected area of
memory. A station' s Call Forward status is returned after a power
failure or system reset occurs.
When a key telephone is forwarded remotely, the key station' s
forward button lights. The station user may cancel the forwarding at
their station by pressing ON/OFF, then the FWD button. SLT users can
cancel their forwarding by going off hook and dialing the forward
code.
DISA callers entering the code and making a mistake are given an
error tone for 3 seconds, silence for 2 seconds, then the dial tone is
returned.
Call Forward