Bootp Client Interface Address Parameters - Nortel Remote Access for AN and Passport ARN Routers Configuration Manual

Configuring Remote Access for AN and Passport ARN Routers

BootP Client Interface Address Parameters

Parameter: IP Address
Path: Configuration Manager > Protocols > IP > BOOTP >
Relay Agent Interface Table > Client I/F > Add
Default: None
Options: Any valid IP address
Function: Specifies the IP address of the router that is using EZ-Install. This parameter
applies only to a Frame Relay PVC in group access mode.
Instructions: Specify the IP address (in dotted-decimal notation) of the router interface.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.8.1.1.1.3
Parameter: DLCI Number
Path: Configuration Manager > Protocols > IP > BOOTP >
Relay Agent Interface Table > Client I/F > Add
Default: None
Options: 16 to 1007
Function: Specifies the identification number of the upstream router's PVC. The Frame
Relay network uses the DLCI number to direct data from the AN/ANH or ARN
router to the upstream router.
Instructions: Specify the number in decimal format. Use the DLCI number assigned by your
Frame Relay service provider.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.8.1.1.1.2
A-8
308614-14.20 Rev 00