Nortel Remote Access for AN and Passport ARN Routers Configuration Manual page 121

Nortel Networks recommends that you fill out the worksheets as follows:
1.
2.
3.
4.
5.
308614-14.20 Rev 00
Fill out the Global Information worksheet completely.
This worksheet lists options common to all synchronous interface
configurations.
After you record your protocol selections on the Global Information
worksheet, fill out one Router Protocol worksheet.
This worksheet lists options for RIP, OSPF, and static route configurations.
For example, if you select RIP as your routing protocol, you need only fill out
the RIP worksheet.
Fill out one Wide Area Protocol worksheet.
This worksheet lists options for Nortel Networks Proprietary PPP, Frame
Relay, Standard PPP, and SMDS configurations. For example, if you select
Frame Relay as your wide area protocol, you need only fill out the Frame
Relay worksheet.
Run install.bat or inst_arn.bat as described in
Script" on page C-13.
Alternatively, a person at the AN/ANH or ARN router remote site can run the
Quick-Start script using a management console modem connection.
Once the router has an initial connection to the network, see Configuring
and Managing Routers with Site Manager to configure the router.
Using the Quick-Start Local Boot Procedure
"Running the Quick-Start
C-3