Ez-Install; 308614-14.20 Rev 00 - Nortel Remote Access for AN and Passport ARN Routers Configuration Manual

You can use Netboot for some procedures and Local Boot for others, provided you
have set up the network to support Netboot.
Note: To boot an AN/ANH or ARN router over the network, all routers in the
path to the BootP server must be running BayRS Version 7.60 or later.

EZ-Install

Complete the following steps for the EZ-Install option:
1.
2.
3.
4.
Note: If the AN/ANH or ARN router will connect to the upstream router over
a frame relay circuit, ensure that the upstream router is running BayRS Version
7.80 or later.
5.
6.

308614-14.20 Rev 00

Use the Configuration Manager in local mode to create a complete
configuration file for the router. (See Chapter 3 and Configuring and
Managing Routers with Site Manager.)
Set up a UNIX workstation on the network to support BootP. (See Chapter 2.)
Create a BootP client on the upstream router to support automated addressing,
and configure all routers between the BootP server and the AN/ANH or ARN
router as BootP relay agents. (See Chapter 3.)
Ensure that there is a network connection from a synchronous interface on the
AN/ANH or ARN router to the upstream router.
A person at the AN/ANH or ARN router site installs and turns on the router.
(See the model-specific hardware installation guide.)
The AN/ANH or ARN router obtains a software image from its local file
system, an IP address from the upstream router, and the customized
configuration file from the BootP server.
describes this process; no action is required.)
If the configuration file meets your network requirements, the AN/ANH or
ARN router starts bridging and routing traffic.
Use the Site Manager Statistics Manager and Events Manager tools to verify
that the AN/ANH or ARN router is routing traffic as specified in the
configuration file. (See Configuring and Managing Routers with Site
Manager.)
Understanding Tools and Options
("The Boot Process" on page 1-5
1-19