Repeater Port Group Parameters - Nortel Remote Access for AN and Passport ARN Routers Configuration Manual

Repeater Port Group Parameters

Parameter: Reset
Path: Configuration Manager (Dynamic mode only) > Platform > Setup Repeater >
Group Parameters
Default: NO_RESET
Options: NO_RESET
Function: Resets the repeater. The Configuration Manager tests each repeater port and
indicates in a log file whether the ports pass the diagnostics. The reset does not
affect the management counters defined in the RFC 1516 MIB specification, nor
does it affect the status of the ports. However, the reset does disrupt traffic flow.
Instructions: Accept the default, NO_RESET, or select RESET.
MIB Object ID: 1.3.6.1.2.1.22.1.1.4
Parameter: Selftest
Path: Configuration Manager (Dynamic mode only) > Platform > Setup Repeater >
Group Parameters
Default: NO_SELFTEST
Options: NO_SELFTEST
Function: Causes the router to perform an agent-specific test on itself. This test does not
disrupt traffic flow.
Instructions: Accept the default, NO_SELFTEST, or select SELFTEST.
MIB Object ID: 1.3.6.1.2.1.22.1.1.5
308614-14.20 Rev 00
|
RESET
|
SELFTEST
Site Manager Parameters
A-9