Nortel Remote Access for AN and Passport ARN Routers Configuration Manual page 93

Parameter: Connector Subnet Mask
Path: Configuration Manager > Protocols > Global Protocols > Net Boot > Interfaces
Default: None
Options: Any valid IP subnet mask
Function: Specifies the network and subnetwork portion of the 32-bit IP address of this
interface. The Configuration Manager automatically calculates an appropriate
subnet mask, depending on the class of the network to which the interface
connects. However, you can change the subnet mask using this parameter.
Instructions: Accept the assigned subnet mask, or specify one in dotted-decimal notation.
MIB Object ID: 1.3.6.1.4.1.18.3.3.2.10.3.1.5
Parameter: Connector Next Hop
Path: Configuration Manager > Protocols > Global Protocols > Net Boot > Interfaces
Default: None
Options: Any valid IP address
Function: Specifies the IP address of the next-hop router connected to this interface. When
the router starts up, the next-hop router passes the BootP requests and responses
that initiate the transfer of the image and/or configuration file between the router
and the BootP server. If the router and BootP server are on the same IP subnet,
you do not have to set this parameter.
Instructions: Specify the IP address of the next-hop router connected to this interface in
dotted-decimal notation.
MIB Object ID: 1.3.6.1.4.1.18.3.3.2.10.3.1.6
Parameter: Connector Protocol Mask
Path: Configuration Manager > Protocols > Global Protocols > Net Boot > Interfaces
Default: Point to Point
Options: Point to Point
Fr Relay Annexa
Function: During the boot process, the router configures the synchronous interface for the
specified protocol.
Instructions: Specify the desired protocol option.
MIB Object ID: 1.3.6.1.4.1.18.3.3.2.10.3.1.7
308614-14.20 Rev 00
|
Point to Point Internal Clock
|
Fr Relay LMI
Site Manager Parameters
| |
Fr Relay Annexd
A-5