Nortel Remote Access for AN and Passport ARN Routers Configuration Manual page 122

Configuring Remote Access for AN and Passport ARN Routers
Global Information Worksheet
This section contains the prompts and options for all AN/ANH or ARN router
synchronous configurations.
Global Information Worksheet
Prompt
Enter the module number
[1]:
Driver Type:
Enter connector number
[1]:
C-4
Options
AN/ANH only: Because the AN/ANH is not a
link module, the router bypasses this step
and automatically accepts a default slot of 1.
ARN only: The script lists the modules that
you can use to connect the router's IP
network interface to Site Manager.
For example, the script might offer the
following options:
1. Ethernet on Base Module
2. Serial on Adapter Module 1
3. Ethernet Tri-Serial on Expansion Module
If there is only one interface on the module
you chose, the script automatically selects
the driver type for that interface and
bypasses this prompt. Otherwise, the script
displays a menu of driver types. The actual
menu depends on the modules you have
installed.
If there is only one connector on the module
you chose, the script automatically assigns a
connector number and bypasses this prompt.
Otherwise, the script lists the available
connectors. For example, for an ARN with
five serial connectors, the options are as
follows:
1. COM1
2. COM2
3. COM3
4. COM4
5. COM5
Your Response
Enter the number that
corresponds to the
module you want to use.
Enter the number that
corresponds to the driver
for the module you
selected.
For serial interfaces and
all WAN adapter modules,
choose the synchronous
driver.
For information about the
module locations and
connector names, see
Tables 3-1 to 3-4 in
Chapter 3.
(continued)
308614-14.20 Rev 00