Netboot Interface Parameters - Nortel Remote Access for AN and Passport ARN Routers Configuration Manual

Configuring Remote Access for AN and Passport ARN Routers

Netboot Interface Parameters

Parameter: Slot
Path: Configuration Manager > Protocols > Global Protocols > Net Boot >
Interfaces > Add
Default: None
Options: 1
Function: Specifies the physical slot in which the hardware module is installed.
Instructions: Specify 1 as the slot. AN/ANH and ARN routers have only one slot.
Parameter: Connector
Path: Configuration Manager > Protocols > Global Protocols > Net Boot >
Interfaces > Add
Default: None
Options: COM1 | COM2 | COM3 | COM4 | COM5 | XCVR1 | XCVR2 | TOKEN1 |
TOKEN2
Function: Specifies the name of the connector configured for the Netboot interface.
Instructions: Specify COM1, COM2, COM3, COM4, or COM5 to configure Netboot over a
synchronous interface.
Specify XCVR1 or XCVR2 to configure Netboot over an Ethernet interface.
Specify TOKEN1 or TOKEN2 to configure Netboot over a token ring interface
(ARN only).
Note that the interfaces that are available depend on the interface options you
purchased with your router.
Parameter: Connector IP Address
Path: Configuration Manager > Protocols > Global Protocols > Net Boot >
Interfaces
Default: None
Options: Any valid IP address
Function: Specifies the IP address of this interface.
Instructions: Specify the IP address of this interface in dotted-decimal notation.
MIB Object ID: 1.3.6.1.4.1.18.3.3.2.10.3.1.4
A-4
308614-14.20 Rev 00