Figure C-1. Quick-Start Ip Configuration Test - Nortel Remote Access for AN and Passport ARN Routers Configuration Manual

Configuring Remote Access for AN and Passport ARN Routers
The script begins to test the IP configuration
Testing local IP interface
ping -IP 192.32.00.000 -r5
IP ping:
IP ping:
IP ping:
IP ping:
IP ping:
This test attempts to ping the Site Manager workstation.
NOTE: If routing has not yet converged, an attempt
Type q<return> to cancel this test.
Enter IP address of Site Manager workstation:
Figure C-1.
To continue with the IP configuration test, enter the IP address for the
10.
Site Manager workstation.
To cancel the test, type
For the ARN only, specify whether you want to configure another
11.
interface.
Type
prompt.
To configure another interface, type
At the Technician Interface prompt, enter
12.
Interface.
After the router creates and tests the configuration, it starts using the information
you entered to bridge and route traffic. To configure the router interfaces using
Site Manager, see Configuring and Managing Routers with Site Manager.
C-16
192.32.00.000 is alive (size - 16 bytes)
192.32.00.000 is alive (size - 16 bytes)
192.32.00.000 is alive (size - 16 bytes)
192.32.00.000 is alive (size - 16 bytes)
192.32.00.000 is alive (size - 16 bytes)
to ping the Site Manager workstation may fail.
this happens, you may either enter a new IP address or
quit and wait a short period of time and try again from
the TI command line.
Quick-Start IP Configuration Test
.
q
to stop the Quick-Start script and return to the Technician Interface
n
(Figure C-1).
to return to step 6.
y
to exit the Technician
logout
If
308614-14.20 Rev 00