Global Information Worksheet - Nortel Remote Access for AN and Passport ARN Routers Configuration Manual

Global Information Worksheet

Prompt
Enter clock source
number [2]:
Enter clock speed number
[10]:
Enter circuit name [S#]: The script displays a default circuit name for
Enter IP address in
dotted decimal notation:
Enter IP subnetwork mask
in dotted decimal
notation:
Is the router connected
to the same local area
network as the Site
Manager workstation?
(y/n) [n]:
Enter routing protocol
number [1]:
Enter wide area protocol
number [1]:
Do you wish to set
SNMP community
management?
(y/n) [n]:
Enter (TFTP) volume
number [1]:
Do you want to enable
FTP? (y/n) [n]:
308614-14.20 Rev 00
Using the Quick-Start Local Boot Procedure
(continued)
Options
1. Internal
2. External
This prompt appears only if you chose an
internal clock source.
The script lists a range of values, with 64K as
the default.
the COM interface you selected (for example,
S11 for COM1 and S12 for COM2).
Enter the IP address for the COM interface.
Enter the subnet mask for the COM interface
IP address.
y(es)
n(o)
1. RIP
2. OSPF
3. Static Route to Site Manager
1. Nortel Networks Point-to-Point Protocol
(Proprietary)
2. Frame Relay
3. Point-to-Point Protocol (PPP) Standard
4. Switched Multimegabit Data Service
(SMDS)
y(es)
n(o)
Setting up SNMP community management is
optional.
The script automatically selects 1 as the
TFTP default volume.
y(es)
n(o)
Enabling FTP is optional.
Your Response
Press the [Return] key.
Press the [Return] key.
Complete the worksheet
for the protocol you select.
Complete the worksheet
for the protocol you select.
C-5