Configuring a Netboot or Directed Netboot Interface
You can use Site Manager to configure a Netboot or Directed Netboot interface.
You do this
1. In the Configuration Manager window,
choose Protocols.
2. Choose Global Protocols.
3. Choose Net Boot.
4. Choose Interfaces.
5. In the scroll box, choose the interface you
want to configure.
6. Set the following parameters:
•
•
•
•
•
Click on Help or refer to the parameter
descriptions beginning on page A-4.
7. Click on Apply, then click on Done.
Note: If you configure more than one interface to Netboot, the first interface to
receive a reply from the BootP server will complete the Netboot process.
308614-14.20 Rev 00
Connector IP Address
Connector Subnet Mask
Connector Next Hop
Connector Protocol Mask
Connector State
Configuring Netboot Services with Site Manager
Site Manager Procedure
System responds
The Protocols menu opens.
The Global Protocols menu opens.
The Net Boot menu opens.
The Netboot Interfaces window opens.
The window shows the parameter values
for that interface.
You return to the Configuration Manager
window.
3-9