Nortel Remote Access for AN and Passport ARN Routers Configuration Manual page 130

Configuring Remote Access for AN and Passport ARN Routers
PPP Worksheet
(continued)
Prompt
Enable CHAP (Challenge
Handshake Authentication
Protocol)? (y/n) [n]:
Does the Remote Peer have PAP
authentication enabled?
(y/n) [n]:
Enable the LQR (Link Quality
Reporting) Protocol?
(y/n) [n]:
Enable use of the Remote Peer
router's LQR Timer?
(y/n) [y]:
(For LQR only)
Number of seconds (1-120)
[3]:
(For LQR only)
Enter [inbound] success rate
percentage (1-100) [90]:
Enter [outbound] success rate
percentage (1-100) [90]:
C-12
Options
y(es)
n(o)
Note: If you answer y(es), the script
requests a CHAP secret for this
interface.
y(es)
n(o)
Note: If you answer y(es), the script
requests the PAP ID and password for
the remote interface.
y(es)
n(o)
See Configuring PPP Services for
information about the Link Quality
Reporting (LQR) protocol and LQR
packets.
y(es)
n(o)
Type y if the remote peer router
maintains its own LQR timer for this
interface. Type n if the router is
responsible for maintaining the timer
for this interface.
Enter the maximum number of
seconds between the transmission of
LQR packets.
Enter the minimum acceptable
success rate (percentage) of packets
transmitted by the peer router and
received on this interface over the last
five LQR periods.
Enter the minimum acceptable
success rate (percentage) of packets
transmitted by this interface and
received by the peer router over the
last five LQR periods.
Your Response
308614-14.20 Rev 00