Table of Contents
Advertisement
Excessive Collision Mode
Power Control
Refresh
After finishing all the settings here, please click OK to activate them.
Vigor1000 Series User's Guide
There are two modes for you to choose when excessive
collision happened in half-duplex condition.
Discard - It determines whether the MAC drops frames
after an excessive collision has occurred. If yes, a frame is
dropped after excessive collision. This is IEEE Standard
802.3 half-duplex flow control operation.
Restart - It determines whether the MAC retransmits
frames after an excessive collision has occurred. If set, a
frame is not dropped after excessive collisions, but the
backoff sequence is restarted. This is a violation of IEEE
Standard 802.3, but is useful in non-dropping half-duplex
flow control operation.
The Configured column allows for changing the power
savings mode parameters per port.
Disabled: All power savings mechanisms disabled.
ActiPHY: Link down power savings enabled.
PerfectReach: Link up power savings enabled.
Enabled: Both link up and link down power savings
enabled.
Click this button to refresh the information for WAN port.
85
Advertisement
Table of Contents
