Table of Contents
Advertisement
Item
Destination Subnet
Source Start Port
Source End Port
(optional)
Destination Start Port
Destination End Port
(optional)
Action
E
x
a
m
p
E
x
a
m
p
Refer to the following example.
1.
Use TSPC mode to connect to IPv6 network.
PC get ipv6 IP: 2001:5c0:1503:7400:30e4:139d:53c8:3a1e
2.
Connect PC to http://www.ipv6.org/ with IPv6 IP address.
A message will appear from the web page:
3.
Set firewall rule to block all TCP traffic from this IP address.
4.
Open IPv6 >> IPv6 Firewall Setup and press Add New Rule.
In the following dialog, please configure the page with the following values.
Vigor1000 Series User's Guide
Description
Type the subnet mask here if you choose Subnet as
Destination IP Type.
Type a value as the source start port. Such value will be
available only TCP/UDP is selected as the protocol.
Type a value as the source end port. Such value will be
available only TCP/UDP is selected as the protocol.
Type a value as the destination start port. Such value will be
available only TCP/UDP is selected as the protocol.
Type a value as the destination end port. Such value will be
available only TCP/UDP is selected as the protocol.
Set the action that the router will perform for the packets
through the protocol of IPv6.
Accept – If the IPv6 packets fit the condition listed in this
page, the router will let it pass through.
Drop - If the IPv6 packets fit the condition listed in this
page, the router will block it.
l
e
:
l
e
:
Welcome to the IPv6 Information Page!
You are using IPv6 from 2001:5c0:1503:7400:30e4:139d:53c8:3a1e
221
Advertisement
Table of Contents
