Table of Contents
Advertisement
Available settings are explained as follows:
Item
User Name
Password
Confirm Password
Tunnel Broker
Tunnel Mode
Auto-reconnect Delay
Keepalive
Vigor1000 Series User's Guide
Description
Type the name obtained from the broker. "Vigor1000" is a
default username applied from
http://go6.net/4105/register.asp. It is suggested for you to
apply another username and password.
Type the password assigned with the user name.
Type the password again to make the confirmation.
Type the address for the tunnel broker IP, FQDN or an
optional port number.
IPv6-in-IPv4 Tunnel- Let the broker chose the tunnel
mode appropriate for the client.
IPv6-in-IPv4 (Native) - Request an IPv6 in IPv4 tunnel.
IPv6-in-IPv4 (NAT Traversal - Request an IPv6 in UDP
of IPv4 tunnel (for clients behind a NAT).
After passing the time set here, the client will retry to
connect in case of failure or keepalive timeout.
0 means not retry.
Yes – Keep the connection between TSPC and tunnel
broker always on. TSPC will send ping packet to make
sure the connection between both ends is normal.
No - The client will not send keepalives.
215
Advertisement
Table of Contents
