Table of Contents
Advertisement
Codecs
Default SIP Account
notice sound will appear to tell the user new phone call is
waiting for your response. Click hook flash to pick up the
waiting phone call.
Call Transfer- Check this box to invoke this function.
Click hook flash to initiate another phone call. When the
phone call connection succeeds, hang up the phone. The
other two sides can communicate, then.
Prefer Codec- Select one of five codecs as the default for
your VoIP calls. The codec used for each call will be
negotiated with the peer party before each session, and so
may not be your default choice. The default codec is
G.729A/B; it occupies little bandwidth while maintaining
good voice quality.
If your upstream speed is only 64Kbps, do not use G.711
codec. It is better for you to have at least 256Kbps
upstream if you would like to use G.711.
Single Codec – If the box is checked, only the selected
Codec will be applied.
Packet Size- The amount of data contained in a single
packet. The default value is 20 ms, which means the data
packet will contain 20 ms voice information.
Voice Active Detection- This function can detect if the
voice on both sides is active or not. If not, the router will
do something to save the bandwidth for other using. Click
On to invoke this function; click off to close the function.
You can set SIP accounts (up to six groups) on SIP
Account page. Use the drop down list to choose one of the
profile names for the accounts as the default one for this
phone setting.
Play dial tone only when account registered - Check this
box to invoke the function.
208
Vigor1000 Series User's Guide
Advertisement
Table of Contents
