Alcatel-Lucent OmniTouch Administration Manual page 31

System Configuration
............................................................................................................................................................................................................................................................
•
If the
controls which trunk supplies the timing clock for all Trunks connected to the server.
If the
no effect.
The
by the server.
Sequential
trunk, and so on. This strategy will use the fewest trunks possible for a call load. This is
the recommended setting for stacked configurations, because it is more efficient to
have an entire conference on a single server.
Round Robin
then to the third trunk, and so on. Using the
evenly across all server trunks.
Note: Destination Number Plan
Type
contact your support representative.
........................................................................................................................................................................................................................
Fill in the
4
each interface.
The settings you select must be compatible with the settings of the T1/E1 trunk(s) to
which you are connecting the Alcatel-Lucent OmniTouch Advanced
Communications Server (ACS). Contact your T1 service provider or PBX vendor if
you do not know these settings. See the Alcatel-Lucent OmniTouch My Teamwork
Unified Conferencing and Collaboration Application Site Preparation Guide for a
complete list of available setting values.
The
traffic. The
available for outside dialing. For T1/CCS, this is 23 (maximum 184 ports per server).
For T1/CAS trunks, this is 24 (maximum 192 ports per server). For PRI or E1 trunks,
this is 30 (maximum 240 ports per server).
Network Termination
NNI (network side) interfaces.
The
cannot be edited. It displays the serial number of the board that is located on the
server.
........................................................................................................................................................................................................................
Click the
5
............................................................................................................................................................................................................................................................
8AL90208USAD ed01
November 20, 2008
If OmniTouch ACS is expected to provide clock on the trunks, then select
.
Internal Oscillator
is
Clock Source PSTN Network
is
Clock Source Internal Oscillator
Load Sharing Strategy
uses the first available port, filling the first trunk, then filling the second
distributes outbound call legs, first to one trunk, then to the next trunk,
can be left as
Unknown
Line Buildout Loss
Number of Channels
Number of Outbound Channels
specifies whether this trunk is set up for UNI (user-side) or
Audiocodes Board Serial Number
button when finished.
Save
, then the
Reference Trunk for Timing
, then the
sets the algorithm for how outbound DS0's are selected
Round Robin
,
Destination Number Type
. If further assistance with these fields is required,
information,
Framing
controls the number of DS0s that are available for voice
controls the number of channels
(TDM Network Interface Module) field
To configure PSTN trunk settings
Reference Trunk for Timing
strategy distributes legs
, and
Source Number
, , and
Circuit Type Line Coding
value
has
for
2 - 1 1