Configure Bonding; Sendmail; Use Bonding - Alcatel-Lucent OmniTouch Administration Manual

System Configuration
............................................................................................................................................................................................................................................................
Figure 2-55
........................................................................................................................................................................................................................
Check the
5
........................................................................................................................................................................................................................
Click
6 Save
E
N D
........................................................................................................................................................

Configure bonding

Interface Bonding allows you to change your network configuration from two separate
interfaces (eth0 and eth1) to a single combined interface (bond0). The first network
address uses bond0 and the second network address uses bond0:1. All packets for both IP
addresses go out through eth0 if it is up, or through eth1 if eth0 is down. In bonding mode,
DHCP is disabled. You must have appropriately configured the switches carrying the
network traffic.
Note:
Figure 2-56 Use Bonding
............................................................................................................................................................................................................................................................
8AL90208USAD ed01
November 20, 2008

Sendmail

Enable Sendmail
.
O S
F T E P S
The MAC Address of eth0 is used for both interfaces.
check box.
Configure bonding
2 - 1 0 1