Connections - Denon ADV-1000 Operating Instructions Manual

r_ CONNECTIONS
• DO not plug in the AC cord until all connections have been
completed.
• Be sure to connect the left and right channels properly (left with
left, right with right).
• Insert the plugs securely. Incomplete connections will result in the
generation of noise.
• Note that binding pin plug cords together with AC cords or placing
them near a power transformer will result in generating hum or
other noise.
• Noise or humming may be generated if a connected audio
equipment is used independently without turning the power of this
unit on. If this happens, turn on the power of the this unit.
• When making connections, also refer to the operating instructions of the other components.
I Connecting the DIGITAL (optical) jacks I
Use these for connections to audio equipment with digital {optical) output
[ ,NOsTESopt[ca, c ab,es f or opt[ca, connections, removing the cap before connecting
AC I20V, 60 Hz
I Subwoofer jack I_
Connect the internal amplifier's subwoofer to the
subwoofer terminal
• TO conduct digital recording onto a digital recorder (CD recorder, MD
recordei, etc) while playing Dolby Digital, 96 kHz PCM sources on
this DVD player
• Set the "AUDIO SETUP" default setting as shown below (See page
79, 80)
• "DIGITAL OUT" _ "PCM"
"LPCM SELECT" _ "ON"
Playing DVDs with incorrect settings may result noise that could damage
your ears or the speakers
OUTPUT INPUT
OPTICAL
NOTES:
• Track numbers may not be added automatically when making digital
recordings of CDs being played on the ADV-100O onto a connected
recorder
• When making digital recordings on a CD recorde_, set the CD
recorder's recording setting to manual and add track numbers (track
marks) manually as you record
• When making digital recordings on an MD recordel, use the editing
function after the recording is completed to divide the tracks
Connecting a recorder
]
Connections for recording:
Connect the tape deck's recording input jacks (LINE IN or REC) to this unit's tape
recording (CDR/TAPE OUT) jacks using pin plug cords
Connections for playback:
Connect the tape deck's playback output iacks (LINE OUT or PB) to this unit's
tape playback (CDR/TAPE IN) jacks using pin plug cords
8