Denon ADV-1000 Operating Instructions Manual page 41

[1] 2-channel mode settings
In the auto decode mode, it is possible to automatically conduct multi-channel playback in the Dolby Digital or DTS surround mode or play in
the stereo 2-channel mode (AUTO STEREO mode: factory default setting). For 2-channel input signals, one of four play modes can be set
with the 2-channel mode setting (Auto Stereo, Dolby Pro-Logic [! Cinema, Dolby Pro-Logic l] Music and Dolby Pro-Logic).
•_ When the function is set to VOR, CDR/TAPE or TUNER, the "Auto Stereo" 2-channel mode cannot be selected. To play in stereo,
set the surround mode to "STEREO" (page 35).
t
1
0 @ o JiW _ 0 O00OO
1,3 I
_0
000_ --I
® @......
OOOO
0009 --2
OOO©
Set the surround mode to "AUTO DECODE".
• "AUTO DECODE" is displayed, then the normal display
reappears.
SURROUND FUNCTION
MODE / SELECT
Main unit Main unit
SURROUND
Remote control unit
-_ if the mode is set to anything other than AUTO DECODE,
the AUTO DECODE mode can be set using the AUTO
DECODE/2CH MODE button on the main unit.
Select the desired 2-channel
decode mode using the ( { and
) ) cursor buttons on
the remote control unit.
• The mode switches as follows
each time one of the buttons is
pressed:
Remote control unit
_AUTO ST _ PLII CINEMA
PRO LOGIC _ PLII MUSIC _
"_ if the AUTO DECODE/2CH MODE button on the main unit
is pressed when the mode is already set to AUTO
DECODE, the mode switches to the 2-channel mode. The
mode switches as follows each time the button is
pressed
_AUTO STEREO _ PLO LOGIC|| C •
PRO LOGIC _ PLO LOGIC|| M
-_ The Auto Stereo mode can be selected when the function
is set to DVD, TV/DBS or V.AUX
Once the surround parameters have been set, stop operating
buttons. After several seconds the display returns to normal and
the settings are automatically validated
NOTES:
• The 2-channel decode mode cannot be set when Dolby Digital
5.1-channel signals or DTS signals are being input.
• The 2-channel mode setting is stored in the memory individually
for the DVD, TV/DBS and VAUX modes
Press the SURR.PARA button on the remote control unit and
select the 2-channel decode mode.
12_._! RUTO ST _"
SURRpARA
Remote control unit
"_ This can be selected when the digital input consists of no
signal, PCM signals, Do]by Digital 2-channel signals, as
well as when the analog input is selected
41